Single function · Telehandlers
Low cost, entry-level height limiting for telehandlers.
A simple, low cost height limiter for telehandlers working under overhead hazards. A maximum working height is set, and the system stops the boom going any higher.
Not sure which system you need? Use our System Finder
Entry level
Low cost telehandler height limiting
Telehandlers
Designed for telescopic handlers
Height
Single function height limiter
Since 1992
From a team building safety control systems for nearly 35 years
How it works
The Series 1TH is our specialist height limiter for telehandlers. The operator sets the maximum working height using the in-cab display, then the system stops the boom from going beyond that limit.
01 · ST
A maximum working height is set to suit the job and the site.
02 ·
The system monitors the position of the telehandler boom.
03 · LIMIT
When the boom reaches the limit, the system stops it going any higher.
Where it works
Installation
The Series 1TH can be installed by any competent engineer. If you would rather leave it to us, our engineers and approved partners can fit the system, set it up and show your operators how it works.
Fit the system to the telehandler and mount the display in the cab.
Set the maximum working height on the in-cab display to suit the job and the site.
The system monitors the position of the boom, and when it reaches the limit it stops it going any higher.
Book an annual inspection with us to keep the system working as it should.
Tell us about your machines and where they work, and we will help you choose the right system. Call +44 (0) 1202 861961 or send us a message.
FAQ
The Series 1TH uses a laser-based system to monitor telescopic extension. The Series 1H suits standard boom machines such as tracked and wheeled excavators, backhoe loaders, and tractors.
Yes. A height limiter stops the boom at a set height, which helps when working beneath overhead hazards such as power lines. Always use it as part of your lift plan and safe system of work.
The limit is set by the operator or supervisor to suit the job and the site. The system comes with a key switch, so a supervisor or site manager can set the limits and remove the key, meaning they can't be changed by operators.
No. For rail work, choose the Series 2HS Evo or Series 2LHS Evo, which are Network Rail approved.
Yes. The Series 1TH is suitable for self-installation. If you prefer, our engineers and approved partners can fit it for you.
Other civils products

Single function
Height limitation to protect from overhead obstacles or danger.
View product →
Single function
Height limitation for larger machines with two and three piece booms.
View product →