Single function · Civils
Effective protection from overhead danger.
A simple, accurate and cost-effective height limiter, suitable for self-installation. It protects workers from overhead danger when it is hard to judge the machine's height from the cab.
Not sure which system you need? Use our System Finder
Height
Single function height limiter
12 / 24V
Works with 12V or 24V motion cut coils
Self-install
Designed to be fitted by your own team
IP67
Gravity-referenced boom sensor
How it works
The operator sets a height limit on the display. The Series 1H monitors the angle of the boom and cuts the lift circuit if that limit is reached, so the boom cannot go any higher.
01 · DETECT
Mounted on the lifting boom. It measures against gravity rather than the machine body, so the height limit stays accurate when the machine is working on a slope.
02 · ALERT
Fitted in the cab on a RAM mount. Simple controls let the operator set the limit, and the integrated key switch keeps the settings secure.
03 · LIMIT
A relay output changes state at the limit. It drives a hydraulic solenoid valve to cut the lift circuit, and can also drive an external alarm or beacon.
Where it works
Technical specifications
Taken from the Series 1H product brochure. If you need more detail for your machine, our team can help.
| Electrical | |
|---|---|
| Motion cut | Compatible with 12V or 24V coils |
| Output | Relay output that changes state at the height limit. Drives a hydraulic solenoid valve, or an external alarm or beacon |
| Mechanical | |
| Sensor type | Gravity-referenced angle sensor, IP67 rated |
| Display | LED display with integrated key switch, IP64 rated, RAM mount to window or dashboard |

The Series 1H display, and an illustration of the height limit it sets on an excavator boom.
Installation
The Series 1H is designed for self-installation. If you would rather leave it to us, our engineers and approved partners can fit the system, set it up and show your operators how it works.
Mount the angle sensor on the lifting boom and the display in the cab, then wire the output to a hydraulic solenoid valve on the lift circuit.
Set the height limit on the display. The key switch keeps the setting secure.
The system monitors the angle of the boom and cuts the lift circuit if the limit is reached, so the boom cannot go any higher.
Book an annual inspection with us to keep the system working as it should.
Tell us about your machines and where they work, and we will help you choose the right system. Call +44 (0) 1202 861961 or send us a message.
FAQ
Yes. The Series 1H is designed for self-installation. If you prefer, our engineers and approved partners can fit it for you.
No. The angle sensor is gravity-referenced rather than referenced to the machine body, so the height limit stays accurate when the machine is working on an incline.
Yes. As well as cutting hydraulic movement, the output can drive an external alarm or beacon.
No. The Series 1H is a standalone system with its own sensor and display. It cuts movement through a hydraulic solenoid valve on the lift circuit.
No. For work near the running line, choose the Series 2HS Evo or Series 2LHS Evo, which are Network Rail approved.
Downloads
Download the Series 1H product brochure for an overview of the system and its specification.
Other civils products


Combined function · Rail certified
Height and slew control with virtual walls, dig mode and Network Rail approval.
View product →
Single function · Telehandlers
Low cost, entry-level height limiting for telehandlers.
View product →